Mercedes SLK World banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
123 Posts
Discussion Starter #1
Ok so I took the car out yesterday after working on it for the week getting it ready from being in storage. The car ran great. Then me and my wife had luch and when we got back in it, there was no acceleration, I would stomp on the pedal and it would slowly gain speed. It stalled going up a hill, so I turned it off took the key out and restarted her..... and everything has worked fine ever since.

This seems to happen once or twice a year to the car, any suggestions to what it is, K40?

I don't think its the MAF, I just replaced with a new one from MB. Throttle body is in great shape, and all wires to and from engine look good. the spark plugs were just changed, so what could do this once in a blue moon?

Its just making me :tazz:
 

·
Registered
Joined
·
123 Posts
Discussion Starter #5
Ok well after driving it around and checking pending codes, I found that codes p0100, p0101, and p1580 all we pending. So I took apart the intake from the MAF to Throttlebody. What I found was that O-ring by the MAF was not making a good seal. When the car was under acceleration, the seal was bleeding off pressure from the S/C. this threw all three codes at once. I made rubber seal to help with the O-ring and now theres no air escaping. thus no CODES and NO Bogging down.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top