Mercedes SLK World banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
Hi all. Before I take the plunge and refit a carbon element to my drivers seat, I wonder if someone could give me their advice please? My drivers bottom element does not get warm, but the back does and I'm sure the side bolsters do too. However, unlike all of the posts I've read, my heated seat switch stays on and works the heating as normal (without the base). Reading through posts (with the guidance of J Banks), my assumption is that a malfunctioning heated base would lead to an incomplete circuit, meaning that the switch should go out after a few seconds. Is this correct? I intend having an upholsterer take the seat apart, but wanted to check if there may be another cause first?

Ian
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top